Skip to content
CV Automation SolutionsES

Solutions

UPS and battery banks for control systems

We size and install UPS units, rectifiers and battery banks so controllers, communications and instruments keep running during a power outage. The calculation starts from the connected load and the backup time the operation needs.

In detail

A power outage should not leave the control room blind. At remote sites the problem is bigger: if the radio or PLC shuts down, nobody knows what is happening in the field until someone gets there.

We have installed UPS units and battery banks on well pads and test separators, and UPS units and rectifiers in crude gathering automation infrastructure. We also maintain existing backup systems.

What’s included

  • Connected load and backup time calculation
  • Sizing and procurement of UPS units, rectifiers and batteries
  • Installation and startup
  • Maintenance of existing backup systems

Platforms and manufacturers we work with

How we do it

  1. 1

    Load

    Inventory of equipment that must stay on and its consumption.

  2. 2

    Autonomy

    Required backup time and bank sizing.

  3. 3

    Installation

    Installation, transfer tests and documented handover.

In the field and in the control room

Operator at the control panel of a power plant
Operator at the control panel of a power plant
Motor control center with soft starters and drives
Motor control center with soft starters and drives
Technician checking a low voltage switchboard with a tablet
Technician checking a low voltage switchboard with a tablet

Frequently asked questions

How much backup time do I need?

It depends on how long it takes to restore power or get staff to site. We calculate it with you from the connected load.